Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:This kit contains most of the seals and gaskets necessary to rebuild an engine.
This kit contains most of the seals and gaskets necessary to rebuild an engine. You'll also need to purchase a flywheel seal. If your case is a dual relief motor, you'll also need another copper o-ring for the second relief plug and two more of the oil cooler seals. Note: We use a sealer called Gasgacinch on all our gaskets.
No customer reviews for the moment.
Part #: 113101157C
This plug goes in the back of the case (flywheel side).
Application:Part #: N110104
Some of the more common nuts you might need..
Application:Part #: 043101129
This is the washer used under the nuts on cases that use an o-ring on the center main studs.
Application:Part #: 1101131
A case saver is an insert that repairs worn or stripped head stud holes in a case.
Application:Part #: 113101211G
It's possible to put a generator on an alternator stand but not the other way around.
Application:Part #: 1101146
These cheater studs replace the head studs that have pulled from the case.
Application:Part #: N110085
Some of the more common nuts you might need..
Application:Part #: 1101131B
A case saver is an insert that repairs worn or stripped head stud holes in a case.
Application:Part #: 1198035
If you are converting a single port engine to a dual port or if you have a brand new case; these are the head studs you're looking for.
Application:Part #: 1101157
This cam plug is made out of billet alluminum and has an o-ring on it.
Application:Part #: 1101031
Included in this kit are the bolts, nuts and washers required for "out to head" assembly of the engine..
Application:Part #: 1101113KT
This kit has all the oil galley plugs in it.
Application:Part #: 111199101
These are the bolts that hold the engine in.
Application:Part #: 111101191
25/36 HP Engine Case/ Generator Gasket
Application:Part #: N115244
This is a general rule for washer use, wafer washers are used against aluminum and lock washers are used against steel..
Application: