Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This kit has the correct studs for a dual port engine to hold the heads on. 10mm
10mm studs.
No customer reviews for the moment.
Part #: 6012904Y
This pole has a light on the top of it, just above the flag.
Application:Part #: 371881795A
Seat Paperboard Backing, Set of 2
Application:Part #: 6109335
These shields help protect your pushrod tubes.
Application:Part #: 2411300B
These heavy duty sway bars help eliminate swaying.
Application:Part #: 111711611IV
This knob fits on the heater control.
Application:Part #: 6601007WH
These are the most popular off road wheels.
Application:Part #: 1109302
These push rods are made out of chromoly steel and do not expand at the same rate as aluminum.
Application:Part #: 6615103A
Rear Rotor for Disc brake setup, 4x130 bolt pattern, 14x1.5mm threads
Application:Part #: 1127109
This is a brass tee for dual carbs.
Application:Part #: 211955511B
This switch controls the wiper motor.
Application:Part #: 133415801
These two rods go from the center tie rod on a Bug, to the spindles, making the car turn.
Application:Part #: 211841549
Cargo Door Hinge Screw Plug, 8 per car, Sold each
Application:Part #: 071251185A
Tail pipes route the exhaust out of the back of the stock muffler..
Application:Part #: N138211
These are the gaskets used between the intake manifold and the cylinder head.
Application:Part #: 211837211A
This seal goes between the handle and the body.
Application:
This kit has the correct studs for a dual port engine to hold the heads on. 10mm