Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This plug goes in the back of the case (flywheel side).
This plug goes in the back of the case (flywheel side). We usually seal this plug into the case with 3M glue. If you have a manual transmission, put the open side of the plug in towards the cam. If you have an automatic transmission, the open side goes towards the flywheel. Note: Don't get carried away with applying sealer, as it may fill the cam bearing on the end of the shaft.
Bug (Type 1): 65-79
Bus (Type 2): 63-79
Vanagon: 80-83
Type 3: 62-73
Ghia: 61-74
Thing: 73-74
Race/Off-Road: 65-79
No customer reviews for the moment.
Part #: 113198033
We only carry new dual relief cases.
Application:Part #: 111101123
These pins position the main bearings in the case halves so you can line up the oil galley holes with the main bearings.
Application:Part #: N0145051
Some of the most common studs you might need.
Application:Part #: 1115139
When plumbing the oil filter, oil cooler and/or case, these are the fittings you will need.
Application:Part #: 113105245FRS
Rear Main Seal, Double Lipped
Application:Part #: N110085
Some of the more common nuts you might need..
Application:Part #: 111115421
Oil Relief Valve Spring 25-36 HP
Application:Part #: N105001
These are the bolts that hold the engine in.
Application:Part #: 1101157
This cam plug is made out of billet alluminum and has an o-ring on it.
Application:Part #: 1198035
If you are converting a single port engine to a dual port or if you have a brand new case; these are the head studs you're looking for.
Application:Part #: 1101113KT
This kit has all the oil galley plugs in it.
Application:Part #: 1101030
Included in this kit are the bolts, nuts and washers required for "out to head" assembly of the engine..
Application:Part #: 111198001
Engine Gasket Set, 25 HP
Application:Part #: 1101461KIT
This kit has the correct studs for a dual port engine to hold the heads on. 10mm
Application:Part #: 113101221B
It's possible to put a generator on an alternator stand but not the other way around.
Application:
This plug goes in the back of the case (flywheel side).
