Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This kit contains most of the seals and gaskets necessary to rebuild an engine.
This kit contains most of the seals and gaskets necessary to rebuild an engine. You'll also need to purchase a flywheel seal. If your case is a dual relief motor, you'll also need another copper o-ring for the second relief plug and two more of the oil cooler seals. Note: We use a sealer called Gasgacinch on all our gaskets.
Bus (Type 2): 79
Vanagon: 80-83
No customer reviews for the moment.
Part #: 1101146
These cheater studs replace the head studs that have pulled from the case.
Application:Part #: 1101157
This cam plug is made out of billet alluminum and has an o-ring on it.
Application:Part #: 1198035C
Chromoly 8mm Head Stud Kit
Application:Part #: 1101031
Included in this kit are the bolts, nuts and washers required for "out to head" assembly of the engine..
Application:Part #: 029198009
This kit contains most of the seals and gaskets necessary to rebuild an engine.
Application:Part #: 1101461KIT
This kit has the correct studs for a dual port engine to hold the heads on. 10mm
Application:Part #: N122412
This is a general rule for washer use, wafer washers are used against aluminum and lock washers are used against steel..
Application:Part #: 111101123
These pins position the main bearings in the case halves so you can line up the oil galley holes with the main bearings.
Application:Part #: 113101211G
It's possible to put a generator on an alternator stand but not the other way around.
Application:Part #: N145431
Some of the most common studs you might need.
Application:Part #: 2101000
This is for converting a non hanger case to accept a hanger.
Application:Part #: N110104
Some of the more common nuts you might need..
Application:Part #: N110062
Some of the more common nuts you might need..
Application:Part #: 111198003
This kit contains most of the seals and gaskets necessary to rebuild an engine.
Application:Part #: N144031
Some of the most common studs you might need.
Application:
This kit contains most of the seals and gaskets necessary to rebuild an engine.
