Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This disc transfers the power from the motor to the transmission. To check an old clutch disc, use a 7mm wrench and try to put the open end over the thickness of the disc. If the wrench goes on, you should think about replacing the disc. There are basically two types of discs, ridged and one with springs. The spring type has a little give before it engages, reducing the shock on the transmission. The ridged discs are good for dirt cars or someone who wants to race at the drag strip.
Bus (Type 2): 74-75
No customer reviews for the moment.
Part #: 091141701
This shaft holds the throw-out bearing in place.
Application:Part #: 029141031A
This disc transfers the power from the motor to the transmission.
Application:Part #: 251721263A
This slave cylinder moves the clutch arm, releasing the clutch.
Application:Part #: 111141031F
This disc transfers the power from the motor to the transmission.
Application:Part #: 2141701B
This heavy duty arm is a good idea if you need a new clutch arm.
Application:Part #: 1141027
Kennedy Stage 3 Pressure plate 2600 LB
Application:Part #: 1141033
Cushion Clutch Disc - 200mm
Application:Part #: 311141025E
The clutch cover is also known as a pressure plate.
Application:Part #: 1141025
Heavy Duty Clutch Pressure Plate - 1700lbs. This is made by KEP
Application:Part #: 1198026A
This kit contains a quality urethane bushing, a clutch return spring and retaining clips needed to install the throw-out bearing arm in the transmission.
Application:Part #: 2141701A
This heavy duty arm is a good idea if you need a new clutch arm.
Application:Part #: N122412
This is a general rule for washer use, wafer washers are used against aluminum and lock washers are used against steel..
Application:Part #: 1141030
200mm 6 puck Clutch Disc
Application:Part #: N102401
This is a list of the most common bolts used on a car..
Application:Part #: 113141701C
This shaft holds the throw-out bearing in place.
Application:Part #: 131141719HDL
Clutch Cable Arm Forged for 16mm Cross shaft
Application:
