Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:This is part of the filler neck.
Bus (Type 2): 74-79
No customer reviews for the moment.
Part #: 211201551R
Gas Cap Locking, includes gasket
Application:Part #: 111201551AL
Locking Gas Cap
Application:Part #: 211201131D
Fuel Filler Retaining Ring
Application:Part #: 113919133
The sending unit registers the fuel level on the gauge.
Application:Part #: 111201557B
Gas Cap Gasket, 100mm
Application:Part #: 211201521A
Truck Hard Fuel line Tank to Motor
Application:Part #: 211255463
Fuel Filler Hose, Hose Clamp
Application:Part #: 311971907
Turn Signal Switch Grommet for Type 1, fuel pump and backup harness grommet on late Type 2, and main harness through body early Type 2
Application:Part #: 271919051B
The sending unit registers the fuel level on the gauge. 7 1/2" long
Application:Part #: 211919051
The sending unit registers the fuel level on the gauge.
Application:Part #: 211201055B
These are new Brazilian tanks.
Application:Part #: 133133511
This filter goes in line with the fuel line, keeping dirt or rust out of the carburetor.
Application:Part #: 211201255
This collar goes around the gas tank neck on buses 1955-1967.
Application:Part #: N122412
This is a general rule for washer use, wafer washers are used against aluminum and lock washers are used against steel..
Application: