Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
Generators supply the battery with voltage.
Generators supply the battery with voltage. To test a 12v generator, take the wires off the D+ and the DF terminals. Grab a volt meter and hook up the volt meter so the positive lead goes to the D+ and the negative to the DF. Now run a jumper wire from the DF to the D-. Start the car and rev the motor. If the meter pegs, the generator is good and if it doesn't, then it's bad. Now if the meter jumps to lower voltage the generator may need to be polorized. To polorize a generator, make sure the voltage regulator wires are still disconnected. Take off the generator belt. Using a battery with jumper cables, hook up the positive to the D+ and the negative to D-. Now with a jumper wire, go from the DF to the body of the generator. Hold the wire there just long enough to see the generator spin like a motor; no longer, or you will burn up the generator. Some generators are sold on exchange.
Bug (Type 1): -66
Bus (Type 2): -64
Ghia: -66
Race/Off-Road: -66
No customer reviews for the moment.
Part #: 113903141A
The generator strap goes around the generator and holds the generator to the stand..
Application:Part #: 111119141A
Cooling Fan Nut
Application:Part #: 042903109ABR
This is the pulley on the generator that holds the belt.
Application:Part #: 111119270B
This is a hub that is keyed onto the generator or alternator to mount the fan.
Application:Part #: 1903184
Nut for Billet Pulley Only
Application:Part #: 111903137E
This is the belt that turns the generator.
Application:Part #: 113903141B
The generator strap goes around the generator and holds the generator to the stand..
Application:Part #: 113971901A
This boot goes over the wire and the terminal of the generator or alternator.
Application:Part #: JC86010
Jaycee Billet Alternator Pulley, Black
Application:Part #: 1903109SHIM
Billet Alternator/Generator Pulley Shim Kit (Pack of 5)
Application:Part #: 111903137B
This is the belt that turns the generator.
Application:Part #: 1903109BL
Billet Alt/Gen Pulley Blue
Application:Part #: 111903131A
Probably the most common cause of generator pulleys coming apart is the shortage of shims.
Application:Part #: 111903181
Generator Pulley Nut
Application:Part #: 30049
This little box tells the alternator what to do. This is a german one but is not Bosch
Application:Part #: 1903109BORD
Billet Pulley Outer Half Red
Application:
Generators supply the battery with voltage.