Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This is what starts the car.
This is what starts the car. It usually quits the furthest place from home. To bench test a starter is tough, as they can work but are weak. In other words, it will work on the bench, but as soon as it has the drag of the engine on it, it won't. The way we test starters is in the car with a remote starter button (a push button with two long wires). Disconnect the battery. Hook up one of the wires to the big post that the battery cable is hooked to and the other wire to where the push-on wire is located. Now connect the battery back up and make sure the E-brake is on and the car is out of gear. Push the remote starter button. If the engine turns over the starter is good, and if it doesn't, it's bad. If you find the starter works with the remote starter but not with the key, call us. You might need a hard start relay or a new electrical part in the ignition switch. Some starters are sold on exchange.
Bug (Type 1): 68-
Bus (Type 2): 72-83
Type 3: 68-
Ghia: 68-
No customer reviews for the moment.
Part #: 111903137B
This is the belt that turns the generator.
Application:Part #: 043903109BR
This is the pulley on the generator that holds the belt.
Application:Part #: 1119031BHD
Motors with high horsepower and motors that rev fast run the risk of exploding a stock fan.
Application:Part #: 1903532
This is just a cover that fits around a 30amp generator to give it that chrome look.
Application:Part #: 113903515
These are the bearings and brushes for your generator.
Application:Part #: 111903131A
Probably the most common cause of generator pulleys coming apart is the shortage of shims.
Application:Part #: SR11XCO
This is what starts the car.
Application:Part #: 30049
This little box tells the alternator what to do. This is a german one but is not Bosch
Application:Part #: 211903183
This is the bell shaped spacer that hold the outer half of the generator pulley on.
Application:Part #: 113903141B
The generator strap goes around the generator and holds the generator to the stand..
Application:Part #: 1903109BORD
Billet Pulley Outer Half Red
Application:Part #: 111903515A
These are the bearings and brushes for your generator.
Application:Part #: SRHT6V
A 6volt gear that fits the high torque starter.
Application:Part #: AL8275
This unit supplies the battery with voltage.
Application:Part #: 1301104
This bushing is made to mate mismatched bellhousing and starter combinations.
Application:Part #: GR15NC
Generators supply the battery with voltage.
Application:
This is what starts the car.
