Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This is the pulley on the generator that holds the belt.
This is the pulley on the generator that holds the belt. When replacing the pulley, make sure you have a total of eight shims. Place the pulley half, with the key way in it, on the generator. Install three shims, the belt and the other pulley half. Now place the other five shims on the generator, then the bell and the nut. Tighten the nut, letting the belt slip and the engine turn. Once the belt has ridden all the way up, use a screwdriver in the slot and tighten the nut. Check the tension of the belt. If it's too loose, take out a shim in the middle and add it to the outside. If it's too tight, add one from the outside to the middle. Note: If you run the belt too tight, you will ruin the bearings in the generator. It is imperative you have a total of eight shims, otherwise you will be throwing pulleys and buying a new generator.
Bug (Type 1): -66
Bus (Type 2): -66
Ghia: -66
Race/Off-Road: -66
No customer reviews for the moment.
Part #: 1903109BORD
Billet Pulley Outer Half Red
Application:Part #: SR15NC
This is what starts the car.
Application:Part #: 1903109CH
This is a stock generator pulley that has been chromed.
Application:Part #: 1903141B
This strap is much stronger than the stock strap, not that you need a super strap to hold the alternator or generator.
Application:Part #: N127051
This is the pulley on the generator that holds the belt.
Application:Part #: 1903184
Nut for Billet Pulley Only
Application:Part #: GR15XCO
Core Charge Generators supply the battery with voltage. Rebuilt
Application:Part #: 1903109BIL
Billet Aluminum Pulley - 12 volt alt/gen
Application:Part #: GR15NC
Generators supply the battery with voltage.
Application:Part #: JC86030
Jaycee Billet Alternator Pulley, Silver
Application:Part #: 043903109GR
This is the pulley on the generator that holds the belt.
Application:Part #: 111903221A
These are the bearings and brushes for your generator.
Application:Part #: GR11XCO
Generators supply the battery with voltage.
Application:Part #: 043903109BR
This is the pulley on the generator that holds the belt.
Application:Part #: JC86000
Jaycee Billet Alternator Pulley, Blue
Application:Part #: 1903109BOBL
Billet Pulley Outer Half Blue
Application:
This is the pulley on the generator that holds the belt.
