Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This is a list of the most common screws you might need. We use these on the Bus safari frame joining tab.
This is a list of the most common screws you might need. For mounting WG style Safari Latches
Bug (Type 1): All
Bus (Type 2): All
No customer reviews for the moment.
Part #: 1511245
These grommets go on the spring plates in the torsion housing of your car.
Application:Part #: 113823731BGR
This is the seal that goes on the body for the front hood to sit on.
Application:Part #: 111827331A
Engine Deck Lid Spring
Application:Part #: 1601033
Fuchs Polished, 5x205, 15x4.5"
Application:Part #: 131711141BK
This is the knob on top of the shifter..
Application:Part #: 141701061
This is one entire half of the pan.
Application:Part #: 6501281
Billet Aluminum Bearing Cap, Each
Application:Part #: 211813356GWW
Rear Lower Corner, Right, from bottom to beltline
Application:Part #: 221843698B
Side Sliding Door Latch Cover
Application:Bus (Type 2); 68-79
Part #: 211831721DBR
Front door seals keep out the wind, rain, dirt and noise.
Application:Part #: 211945241R
These are the rear lenses for the tail light, brake light and turn signal light.
Application:Part #: 113971901A
This boot goes over the wire and the terminal of the generator or alternator.
Application:Part #: 111998160
Wiper Shaft, 1 Pin, Right
Application:Part #: T1109309
These clips hold the lifters in place while putting the case halves together.
Application:Part #: 311611015J
This hydraulic cylinder feeds all the wheel cylinders.
Application:Part #: 1119023
This spacer kit uses 1 1/4" thick aluminum spacers to close the gap between the fan shroud and the cylinder tins where the sheet metal screw attaches.
Application:
This is a list of the most common screws you might need. We use these on the Bus safari frame joining tab.
