Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These are the seals that go around the final drives on an IRS transmission.
These are the seals that go around the final drives on an IRS transmission. To get the inner one out use a screwdriver to poke it through the seal and pry it out.
Bus (Type 2): 68-79
No customer reviews for the moment.
Part #: 002301189C
These are the seals that go around the final drives on an IRS transmission.
Application:Part #: 2311123
This steel thrust plate stops movement of the main shaft bearing and aids in the keepin the alignment of the gears on the main and pinion shafts.
Application:Part #: 111398005A
This kit contains all of the gaskets needed to rebuild a transmission.
Application:Part #: 2301150
This is a bolt on kit that reduces torsional stress felt at the front of the nose cone mount and rotational stress on the bell housing mounts.
Application:Bus (Type 2); 56-67
Part #: 211598600
Lock Plate Kit for Reduction Boxes
Application:Part #: n122951
Reduction Box, Locking Ring, 1 per side
Application:Part #: 113301155
This is the bushing between the bellhousing of the transmission and the starter.
Application:Part #: 1301048I
Padded Trans Support Front Kit
Application:Part #: 211501273A
This gasket goes between the reduction box halves.
Application:Part #: 211501249
This large soft plug is on the back side of reduction boxes with the 46mm axle nut.
Application:Part #: 6501141
These retainers help stiffen the plates that bolts the tubes to the trans.
Application:Part #: 211501273
This gasket goes between the reduction box halves.
Application:Part #: 211501293A
This nut goes on the inner side of the lower axle shaft of your large nut (46mm) recution boxes.
Application:Part #: 113301185A
This kit contains all of the gaskets needed to rebuild a transmission.
Application:Part #: 211301215
This is the front of the transmission that houses the shift lever.
Application:
These are the seals that go around the final drives on an IRS transmission.
