Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These two rods go from the center pin on a Bus or the pitman arm on a Bug, to the spindles, making the car turn.
These two rods go from the center pin on a Bus or the pitman arm on a Bug, to the spindles, making the car turn. To inspect the rods, have a friend turn the steering wheel back and forth a little while you place your hand on the top of one of the tie rod ends. If you can feel the end jump up and down before it pushes or pulls, it's bad. On some tie rods it's possible to change just the ends. On other tie rods, the ends are swedged on and the whole tie rod will need to be replaced. Usually you replace just the end unless the rod is bent or has the swedged ends.
No customer reviews for the moment.
Part #: N0145051
Some of the most common studs you might need.
Application:Part #: 211405371AWG
These are reconditioned arms with new ball joints pressed in. They are sold on an exchange basis. If you would like to order these before sending your old arms in, please add part number 211405371WGC to your order. That is the core charge. Once you send back your old arms we will refund that amount, providing your arms are good.
Application:Part #: 311611067C
This hydraulic slave cylinder is found in the rear brake backing plate.
Application:Part #: 113129027H
This is what delivers gas and air to the engine.
Application:Part #: 211837219E
Key Blank, (A,D,E,F,V,Z) Profile
Application:Part #: 211943901C
This bracket holds the license plate to the car.
Application:Part #: 1711333BIL
Billet E-Brake Button
Application:Part #: 113821021M
These new front fenders are not as thick as the original German fenders.
Application:Part #: N177382
These are some of the fuses and bulbs that you might need.
Application:Part #: 111711691
These little boots fit on the end of the heater tubes where the cables run through.
Application:Part #: 1127101ALF
This is stainless steel braided fuel line.
Application:Part #: 113405615DGR
These are the front drums that the brake shoes ride on.
Application:Part #: 211703071B
Front End Support Kit (3 Pcs) Inner Structure
Application:Part #: 1105258
This is a stock, zinc-plated crankshaft pulley bolt that has a 3/8" drive hole broached into the center.
Application:Part #: 311919051
Fuel Tank Sending Unit
Application:Part #: 151871375
Convertible Top Latch Hook
Application:
These two rods go from the center pin on a Bus or the pitman arm on a Bug, to the spindles, making the car turn.