Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These come in sets of four pistons with rings, four cylinders, four wrist pins and eight wrist pin keepers.
These come in sets of four pistons with rings, four cylinders, four wrist pins and eight wrist pin keepers. We prefer the Cima Mahle brand for the 1200-1600cc engines. We do not like the wire type of wrist pin keepers and suggest you buy a set of Tru-Arc type keepers. When you get pistons and cylinders, the pistons need to be taken out of the cylinders and have the cosmoline cleaned off and the ring gaps set. Note: The arrows on the pistons go towards the flywheel. If you want your motor to last, I suggest you flip ahead and read BARREL SHIMS.
Bug (Type 1): 40hp
Bus (Type 2): 40hp
Ghia: 40hp
No customer reviews for the moment.
Part #: 1198159B
These rings are cast iron.
Application:Part #: 311198069F
These come in sets of four pistons with rings, four cylinders, four wrist pins and eight wrist pin keepers.
Application:Part #: 1101372
40 HP Barrel Shims .020 (4)
Application:Part #: 1198090BCH
90.5mm Pistons & Cylinders - 82mm Stroke CHINA
Application:Part #: 11310140105
If you're rebuilding your own heads, you will probably need guides.
Application:Part #: 113101353ERB
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld). Due to a shortage of cores we will need your Cylinder head Cores before sending any Rebuilt heads.
Application:Part #: 311198169A
Rings on the pistons are there to eliminate "blow-by".
Application:Part #: 1107434
Not our favorite type of piston pin keeps.
Application:Part #: 1101384
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 1109398
These rocker studs are much stronger than the stock studs and are .100" longer to allow more flexibility when setting your rocker arm geometry..
Application:Part #: 1101389
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 1198083
All kits come with pistons, cylinders, rings, wrist pins and clips.
Application:Part #: 1101481
These are great valve covers gaskets.
Application:Part #: 1101472
If you like clip on valve covers these are the best that we have seen.
Application:Part #: 111101401B
If you're rebuilding your own heads, you will probably need guides.
Application:Part #: 1198092B
All kits come with pistons, cylinders, rings, wrist pins and clips.
Application:
These come in sets of four pistons with rings, four cylinders, four wrist pins and eight wrist pin keepers.
