Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These two boots connect the intake manifold with the end casting,
These two boots connect the intake manifold with the end casting. It's a good idea to replace them if you have the manifold apart. These are probably the number one source of intake leaks on dual port motors. We have tried the split boots and aren't pleased with them because they tend to leak. It's worth the effort to put the stock boots on. Note: Squirt some oil on the inside of the boots for easier installation.
No customer reviews for the moment.
Part #: 113127521AWG
This metal line goes from the pump around the fan shroud to the flex line that comes from the gas tank.
Application:Part #: 1129604
This air cleaner takes the place of a stock air cleaner.
Application:Part #: 113127511A
Fuel Line, Metal, 6mm Pump to Carburetor
Application:Part #: 113127025D
These stock pumps pump fuel into the carburetor.
Application:Part #: 311133261A
These o-rings should be replaced whenever you replace a fuel injector, or if they are old and cracked.
Application:Part #: 022129707F
The Intake Manifold Gasket (2 are required per engine).
Application:Part #: 111127531A
6mm Fuel Line Ferrule
Application:Part #: 111198551
This kit allows you to rebuild your fuel pump.
Application:Part #: 1129702
EMPI EPC 34 or ICT Manifold kit for Dual Port Type 1 Engines
Application:Part #: 111127591A
Fuel Line Grommet 8mm
Application:Part #: 113127025BCD
These stock pumps pump fuel into the carburetor.
Application:Part #: 1127027
This regulator adjusts the fuel pressure to you carburator.
Application:Part #: 113129701K
Single Port, Intake Manifold, 1500-1600cc, 30mm Base
Application:Part #: 251201511A
Metal Canister Fuel Filter
Application:Part #: 211129627
Air Cleaner Hose, Rubber, joins Remote Air Cleaner to Carburetor
Application:Part #: VCP18
This is a rubber plug that is used to plug off vacuum.
Application:
These two boots connect the intake manifold with the end casting,
