Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
The fuel pump sits on this little stand and it's also the guide for the push rod.
The fuel pump sits on this little stand and it's also the guide for the push rod. If you are going to use an old flange, make sure it's not cracked and that the end has not broken off. Note: Make sure it goes into the case easily. If it doesn't, sand the stem so that it slides into place. Do not over tighten it or you will crack it.
Bug (Type 1): 40hp-1600
Bus (Type 2): 40hp-1600
Type 3: 40hp-1600
Ghia: 40hp-1600
Thing (Type 5): 40hp-1600
Race/Off-Road: 40hp-1600
No customer reviews for the moment.
Part #: 1129612
Single Air Cleaner
Application:Part #: 1129701
We've found that dual carbs work better than any single carburator set up.
Application:Part #: 1129809K
Kadron Air Cleaner Base Gasket (Pair)
Application:Part #: 111198553
Fuel pump rear for 40hp repair kit.
Application:Bug (Type 1); 40hp
Bus (Type 2); 40hp
Ghia: 40hp
Part #: 0280160200
Fuel Pressure Regulator for later air cooled Bugs and Buses
Application:Part #: 1129601EL6
This is a replacement air cleaner for the Weber IDF.
Application:Part #: N138211
These are the gaskets used between the intake manifold and the cylinder head.
Application:Part #: N138231
These are the gaskets used between the intake manifold and the cylinder head.
Application:Part #: 1129604
This air cleaner takes the place of a stock air cleaner.
Application:Part #: 043133241
These two boots connect the intake manifold with the end casting on a stock dual port 1600cc engine.
Application:Part #: 1129717
These gaskets are for upright dual port engines.
Application:Part #: 111127531A
6mm Fuel Line Ferrule
Application:Part #: 1129729
These boots can be put on without taking the intake manifold apart and should be used only in an emergency.
Application:Part #: 1127101S
This is stainless steel braided fuel line.
Application:Part #: 1129718
These gaskets are for upright dual port engines.
Application:Part #: 111127591
Fuel Line Grommet 6mm
Application:
The fuel pump sits on this little stand and it's also the guide for the push rod.