Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This is the front of the transmission that houses the shift lever.
This is the front of the transmission that houses the shift lever. Used ones are fine as long as the bushings are good and they're not cracked. Note: Use a new gasket with Gasgacinch for a sealer. Don't over tighten the 11mm nuts. For those of you who are putting a syncro style trans into a 53-59 Bug, you'll need the Bus nose cone and front mount. Those of you with a 60 Bug, punt.
Bug (Type 1): 67-79
Bus (Type 2): 67-79
Type 3: 67-74
Ghia: 67-79
Thing: 73-74
Race/Off-Road: 67-
No customer reviews for the moment.
Part #: 113301263FA
Rear Transmission Mount, Left or Right good quality sold each
Application:Part #: N122391
Transmission Cradle Bolt Washer
Application:Part #: 1301048I
Padded Trans Support Front Kit
Application:Part #: 113301265E
These rubber mounts hold the transmission in place.
Application:Part #: 1311123
This steel thrust plate stops movement of the main shaft bearing and aids in the keepin the alignment of the gears on the main and pinion shafts.
Application:Part #: 001301207
Nose Cone Bushing, Rear, Late
Application:Part #: 1517122
These diffs add two more spider gears to your differential, plus the housing is way stronger then stock.
Application:Part #: 113311123A
This is the main culprit of a noisy transmission.
Application:Part #: 113301185A
This kit contains all of the gaskets needed to rebuild a transmission.
Application:Part #: 001301209
Nose Cone Bushing, Front, Late
Application:Part #: 1301048
These straps are a good idea if you have a car with a big engine. We highly recomend that you use these in conjunction with the urethane transmission mounts.
Application:Part #: 1301263
These mounts made of urethane never wear-out.
Application:Part #: 1301265L
Urethane Front Transmission mount with Hardware
Application:Part #: 311301265A
These rubber mounts hold the transmission in place.
Application:Part #: 113311113A
This seal goes around the mainshaft.
Application:Part #: 113301189F
These are the seals that go around the final drives on an IRS transmission.
Application:
This is the front of the transmission that houses the shift lever.
