Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This is the main culprit of a noisy transmission. The way to check your bearing is to push the clutch in while you are driving. If the noise goes away, then it's the mainshaft bearing. When the clutch is in, the throw-out bearing supports the mainshaft which quiets the mainshaft bearing. If your bearing is bad, we suggest you take your transmission to someone who knows transmissions. Replacing this bearing isn't something the average person can do.
Bus (Type 2): 76-83
No customer reviews for the moment.
Part #: 211501249
This large soft plug is on the back side of reduction boxes with the 46mm axle nut.
Application:Part #: 111301257
Transmission Horn Bolt
Application:Part #: 211711171B
Rear Shift Rod, Connects Shift Rod to Transmission
Application:Part #: 113301263
These rubber mounts hold the transmission in place.
Application:Part #: 1311123
This steel thrust plate stops movement of the main shaft bearing and aids in the keepin the alignment of the gears on the main and pinion shafts.
Application:Part #: 113398209
Bushings and a seal for the nose cone.
Application:Part #: 001301207
Nose Cone Bushing, Rear, Late
Application:Part #: 113301155
This is the bushing between the bellhousing of the transmission and the starter.
Application:Part #: 111301155
This is the bushing between the bellhousing of the transmission and the starter.
Application:Part #: 113311113A
This seal goes around the mainshaft.
Application:Part #: 6501141
These retainers help stiffen the plates that bolts the tubes to the trans.
Application:Part #: 2301265
This steel conversion mount enables you to install a later style full syncro trans in your 1959 and earlier model Bus or Truck..
Application:Part #: 211301289A
Nose Cone Boot
Application:Part #: 002517289A
These are the seals that go around the final drives on an IRS transmission.
Application:Part #: 211711155A
Front Shift Rod
Application: