Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These retainers help stiffen the plates that bolts the tubes to the trans.
These retainers help stiffen the plates that bolts the tubes to the trans. They keep the plates from bending and leaking.
Bug (Type 1): -68
Bus (Type 2): -67
Type 3: -68
Ghia: -68
Offroad/Race: -68
No customer reviews for the moment.
Part #: 2311123
This steel thrust plate stops movement of the main shaft bearing and aids in the keepin the alignment of the gears on the main and pinion shafts.
Application:Part #: 1301048
These straps are a good idea if you have a car with a big engine. We highly recomend that you use these in conjunction with the urethane transmission mounts.
Application:Part #: 6301265
Putting a Bus IRS trans into your bug is the way to go, because it comes with a lower ring and pinion stock and is a stronger trans.
Application:Part #: 1301150
Bolt on Center Transmission mount, Urethane stops included
Application:Part #: 113301155
This is the bushing between the bellhousing of the transmission and the starter.
Application:Part #: 1311321
These heavy duty gear keys are rated at twice the strength of stock keys.
Application:Part #: 113517289A
These are the seals that go around the final drives on an IRS transmission.
Application:Part #: 6301266
These mounts should only be used on cars that are not daily drivers.
Application:Part #: 311301343
Sleeve
Application:Part #: 113301265E
These rubber mounts hold the transmission in place.
Application:Part #: 001301209A
Nose Cone Seal Holder
Application:Part #: 111501131
This kit contains all of the gaskets needed to rebuild a transmission.
Application:Part #: 1301048I
Padded Trans Support Front Kit
Application:Part #: 113301189F
These are the seals that go around the final drives on an IRS transmission.
Application:Part #: 1301265L
Urethane Front Transmission mount with Hardware
Application:Part #: 113701173
This bracket is part of the torsion housing.
Application:
These retainers help stiffen the plates that bolts the tubes to the trans.
