Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These tubes go from the case to the heads to house the push rods.
These tubes go from the case to the heads to house the push rods. They also return the oil from the heads to the case. We highly recommend that you replace these whenever you pull the heads off a 1200 through a 1600 engine. The stock tubes have a crush built into each end. If you try to stretch the old ones, they will go back to where they were crushed as soon as they heat up and more than likely leak. Note: You should be careful putting the seals on. It's real easy to cut your fingers. On Buses 1972 on you do not need to replace the old tubes and they can be installed after the heads are on. sold each
Bus (Type 2): 83-91
No customer reviews for the moment.
Part #: 1109612
Stainless steel valves are used in the big valve heads.
Application:Part #: 021109111G
Aluminum Cam Gear
Application:Part #: 021109601A
The two inside valves in the head are the intake valves, which let the gas into the combustion chamber.
Application:Part #: 1109461
These shims are used under the rockers to set the geometry.
Application:Part #: 111109301A
These rods link the cam to the valves.
Application:Part #: 021198541
The cam rides in these bearings.
Application:Part #: 1109403
These shims are used with the Solid Shaft Rocker Kit.
Application:Part #: 111109345
Push Rod tube seal for 36 HP
Application:Part #: 1109401125
Rocker Arms, High Ratio 1.25, w/Bushing, Set
Application:Part #: 022109309
These ride against the cam.
Application:Part #: 1109400
This kit eliminates the clips and spring washers in a rocker shaft set up.
Application:Part #: 2109001
T4 Camshaft Gear, Bolt On
Application:Part #: 2109002
T4 Engle Cam Shaft Dual Pattern FK-65/7 For Solid Lifters
Application:Part #: 022109612D
The two outside valves in the head are the exhaust valves, they let the burned fuel out of the head.
Application:Part #: 113109623C
These springs return the valves back to their seats.
Application:Part #: 113109021DBR
We've had no luck with regrinds, therefore we sell only new camshafts.
Application:
These tubes go from the case to the heads to house the push rods.
