Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:The cam rides in these bearings.
The cam rides in these bearings. We have tried German and Brazilian brands and have had good luck with both. If you are running a 1776cc or bigger engine you should run double thrust bearings. Note: The bearings are installed with the widest one towards the pulley and the narrowest one towards the flywheel. Use oil on the bearings before installing the cam.
No customer reviews for the moment.
Part #: 113101401
If you're rebuilding your own heads, you will probably need guides.
Application:Part #: 1109605
Stainless steel valves are used in the big valve heads.
Application:Part #: 111109611A
Exhaust Valve 36 HP
Application:Part #: 111101401B
If you're rebuilding your own heads, you will probably need guides.
Application:Part #: 11310140108
If you're rebuilding your own heads, you will probably need guides.
Application:Part #: 1109430
These shims are used under the rockers to set the geometry.
Application:Part #: 1109398
These rocker studs are much stronger than the stock studs and are .100" longer to allow more flexibility when setting your rocker arm geometry..
Application:Part #: 113109623C
These springs return the valves back to their seats.
Application:Part #: 311109335
These tubes go from the case to the heads to house the push rods.
Application:Part #: 113109612A
The two outside valves in the head are the exhaust valves, they let the burned fuel out of the head.
Application:Part #: 1109399
1.25 Ratio Rockers ONLY
Application:Part #: 113109641B
These springs return the valves back to their seats.
Application:Part #: 1109406
These shims are used with the Solid Shaft Rocker Kit.
Application:Part #: 1109405
These shims are used with the Solid Shaft Rocker Kit.
Application:Part #: 1109461
These shims are used under the rockers to set the geometry.
Application: