Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
We've had no luck with regrinds, therefore we sell only new camshafts.
We've had no luck with regrinds, therefore we sell only new camshafts. German cams were the best, but are no longer available. These are the best stock grind cams available at this time. Every since Engle has come out with the "90" cam. We don't even sell these cams anymore.
No customer reviews for the moment.
Part #: 113109301D
These rods link the cam to the valves. These are very costly so please call for good used ones.
Application:Part #: 1109451
This style of adjusting screw has a ball with a flat side on the end.
Application:Part #: 1109006
These gears give just a hair more horsepower.
Application:Part #: 113109612
The two outside valves in the head are the exhaust valves, they let the burned fuel out of the head.
Application:Part #: 1109398
These rocker studs are much stronger than the stock studs and are .100" longer to allow more flexibility when setting your rocker arm geometry..
Application:Part #: 1109401125
Rocker Arms, High Ratio 1.25, w/Bushing, Set
Application:Part #: JC91000
Rebuild kit for Jaycee Leak proof Pushrod Tubes
Application:Part #: 111109325
Push Rod Guide, 25-36 HP, Each
Application:Part #: 111109601A
Intake Valve 30mm (each)
Application:Part #: 113109021DBR
We've had no luck with regrinds, therefore we sell only new camshafts.
Application:Part #: 111198541GR
The cam rides in these bearings.
Application:Part #: 1109310
These lifters are made by Engle and have a small hole in the end of them that allows oil to be pumped onto the cam lobe and lifter face.
Application:Part #: 1109406
These shims are used with the Solid Shaft Rocker Kit.
Application:Part #: 111109345
Push Rod tube seal for 36 HP
Application:Part #: 113109601D
The two inside valves in the head are the intake valves, which let the gas into the combustion chamber.
Application:Part #: 11310140105
If you're rebuilding your own heads, you will probably need guides.
Application:
We've had no luck with regrinds, therefore we sell only new camshafts.
