Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
It's possible to put a generator on an alternator stand but not the other way around.
It's possible to put a generator on an alternator stand but not the other way around. This stand holds either a generator or an alternator in place. Note: If you are buying this to change from 6v to 12v don't forget that you will also need to change the strap, pulley and rear generator tin.
Bug (Type 1): 1500-1600
Bus (Type 2): 1500-1600
Ghia: 1500-1600
Thing: 1500-1600
Race/Off-Road: 1500-1600
No customer reviews for the moment.
Part #: N105001
These are the bolts that hold the engine in.
Application:Part #: 111198005
This kit contains most of the seals and gaskets necessary to rebuild an engine.
Application:Part #: 111101191
25/36 HP Engine Case/ Generator Gasket
Application:Part #: N144031
Some of the most common studs you might need.
Application:Part #: 111199102
This nut came on all dual relief cases.
Application:Part #: 1101461KIT
This kit has the correct studs for a dual port engine to hold the heads on. 10mm
Application:Part #: 1198035C
Chromoly 8mm Head Stud Kit
Application:Part #: 043101025
We only carry NEW dual relief cases. Limited supply!
Application:Part #: 1101157
This cam plug is made out of billet alluminum and has an o-ring on it.
Application:Part #: 113101211G
It's possible to put a generator on an alternator stand but not the other way around.
Application:Part #: 113101219
It's possible to put a generator on an alternator stand but not the other way around.
Application:Part #: N110085
Some of the more common nuts you might need..
Application:Part #: 111101123
These pins position the main bearings in the case halves so you can line up the oil galley holes with the main bearings.
Application:Part #: 1101131
A case saver is an insert that repairs worn or stripped head stud holes in a case.
Application:Part #: 1115105E
Oil Pick Up Tube Cut To Length
Application:Part #: N0145051
Some of the most common studs you might need.
Application:
It's possible to put a generator on an alternator stand but not the other way around.
