Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:This kit contains most of the seals and gaskets necessary to rebuild an engine.
This kit contains most of the seals and gaskets necessary to rebuild an engine. You'll also need to purchase a flywheel seal. If your case is a dual relief motor, you'll also need another copper o-ring for the second relief plug and two more of the oil cooler seals. Note: We use a sealer called Gasgacinch on all our gaskets.
Bug (Type 1): 61-65
Bus (Type 2): 60-65
Ghia: 61-65
No customer reviews for the moment.
Part #: 1101461KIT
This kit has the correct studs for a dual port engine to hold the heads on. 10mm
Application:Part #: 1115105E
Oil Pick Up Tube Cut To Length
Application:Part #: 113101157C
This plug goes in the back of the case (flywheel side).
Application:Part #: 1198036
If you are converting a single port engine to a dual port or if you have a brand new case; these are the head studs you're looking for.
Application:Part #: 1101030
Included in this kit are the bolts, nuts and washers required for "out to head" assembly of the engine..
Application:Part #: 111101123
These pins position the main bearings in the case halves so you can line up the oil galley holes with the main bearings.
Application:Part #: 111115421
Oil Relief Valve Spring 25-36 HP
Application:Part #: N110062
Some of the more common nuts you might need..
Application:Part #: N145431
Some of the most common studs you might need.
Application:Part #: 111101191
25/36 HP Engine Case/ Generator Gasket
Application:Part #: 113101219
It's possible to put a generator on an alternator stand but not the other way around.
Application:Part #: 113101221B
It's possible to put a generator on an alternator stand but not the other way around.
Application:Part #: N110104
Some of the more common nuts you might need..
Application:Part #: 111198001
Engine Gasket Set, 25 HP
Application:Part #: 1198035
If you are converting a single port engine to a dual port or if you have a brand new case; these are the head studs you're looking for.
Application: