Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:This is the washer used under the nuts on cases that use an o-ring on the center main studs.
This is the washer used under the nuts on cases that use an o-ring on the center main studs. Note: If you are using case half sealing nuts do not use these washers.
No customer reviews for the moment.
Part #: N110085
Some of the more common nuts you might need..
Application:Part #: 113101221B
It's possible to put a generator on an alternator stand but not the other way around.
Application:Part #: 043101025
We only carry NEW dual relief cases. Limited supply!
Application:Part #: 111101191
25/36 HP Engine Case/ Generator Gasket
Application:Part #: 1101130
A case saver is an insert that repairs worn or stripped head stud holes in a case.
Application:Part #: N105001
These are the bolts that hold the engine in.
Application:Part #: N110104
Some of the more common nuts you might need..
Application:Part #: N104701
These are the bolts that hold the engine in.
Application:Part #: 113101219
It's possible to put a generator on an alternator stand but not the other way around.
Application:Part #: 1115139
When plumbing the oil filter, oil cooler and/or case, these are the fittings you will need.
Application:Part #: N122412
This is a general rule for washer use, wafer washers are used against aluminum and lock washers are used against steel..
Application:Part #: 111199101
These are the bolts that hold the engine in.
Application:Part #: 1198036
If you are converting a single port engine to a dual port or if you have a brand new case; these are the head studs you're looking for.
Application:Part #: N115244
This is a general rule for washer use, wafer washers are used against aluminum and lock washers are used against steel..
Application:Part #: N145431
Some of the most common studs you might need.
Application:Part #: 1198035C
Chromoly 8mm Head Stud Kit
Application: