Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This is a large concave washer that goes on the crank after you have the nose bearing on.
This is a large concave washer that goes on the crank after you have the nose bearing on. It keeps the oil spray, that comes out of the nose bearing, from shooting out of the pulley end of the case. Note: It is installed with the I.D., convex toward the rods and the concave toward the pulley. Be careful not to install it backwards. If you do, it will dig into the case and fill it with shavings and cause a major blow up.
Bug (Type 1): 46-79
Bus (Type 2): 50-71
Type 3: 62-73
Ghia: 56-74
Thing: 73-74
Race/Off-Road: 46-79
No customer reviews for the moment.
Part #: 1105178
This crankshaft is made of E4340 chromoly forging, one of the strongest metals known to man.
Application:Part #: 1903108BLK
EMPI Serpentine Belt System Black
Application:Part #: 111105713A
Rod Bearings .20
Application:Part #: 1105401A
These connecting rods are longer than stock.
Application:Part #: 1105253RD
This is a crank pulley for an upright motor.
Application:Part #: 1105425
These connecting rods are longer than stock.
Application:Part #: 113105251G
This pulley on the end of the crank turns the fan belt.
Application:Part #: 111105305E
It's really a bolt, but that's what everybody calls it.
Application:Part #: 1105277
Here are some flywheel pins that give you more contact surface on the flywheel.
Application:Part #: 111105209
CRANKSHAFT GEAR, timing, 36hp engines
Application:Part #: 111105287
Flywheel Shim 25-36HP, .34mm (0.0135")
Application:Part #: 1105257
This is a billet, zinc plated crankshaft pulley bolt that has a 3/8" drive hole broached into the center.
Application:Part #: 1105279
This gasket is only used if you're having problems with your end play.
Application:Part #: 111105281
Flywheel Shim 25-36HP, .24mm (0.01")
Application:Part #: 111105707A
Rod Bearings .10
Application:Part #: 1105401B
These connecting rods are longer than stock.
Application:
This is a large concave washer that goes on the crank after you have the nose bearing on.
