Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This is a steel gear that goes on the crank to turn the cam.
This is a steel gear that goes on the crank to turn the cam. To get the gear off the crank, use a puller that is designed specifically for this purpose. Never use a hammer and a punch. When the gear is removed with a punch, it distorts the teeth. This causes it to bind the cam gear. If you have the gear off the crank, look for punch marks on the beveled side before you put it back on. Note: The gear is installed with heat. Use a propane torch to heat the gear (without turning it blue). Use a big pair of channel locks pick it up and install. If you do it right, it should slide right on. If it only goes half way, pull it back off with the correct puller and try again. The bevel side always goes toward the rods. Note: Do not forget the main bearing behind the gear.
Bug (Type 1): 61-79
Bus (Type 2): 60-71
Type 3: 62-73
Ghia: 61-74
Thing: 73-74
Race/Off-Road: 61-79
No customer reviews for the moment.
Part #: 111105271CO
Core
Application:Part #: 111105401EMP
New Connecting Rods, 13-1600cc, Set of 4
Application:Part #: 113105701
These are the shells that go in the rods and ride on the crank.
Application:Part #: 111105713A
Rod Bearings .20
Application:Part #: 1105271
If your are going to run a 69mm or a 78 mm counterweighted crank, then you will want to have your flywheel 8 doweled or get a flywheel has been 8 doweled.
Application:Part #: 113105251G
This pulley on the end of the crank turns the fan belt.
Application:Part #: 111198511OS2
Main Bearing Set 1200-1600
Application:Part #: 211105271CRC
These flywheels have been reconditioned and are sold on an exchange basis. This is a rare flywheel so I do not have any in stock. You will need to send in yours first and we can recondition it.
Application:Part #: 113105241A
This is a large concave washer that goes on the crank after you have the nose bearing on.
Application:Part #: 111105287
Flywheel Shim 25-36HP, .34mm (0.0135")
Application:Part #: 111105263A
The bolt that holds the crankshaft pulley on.
Application:Part #: 111105433
Wrist Pin Bushing.
Application:Bug (Type 1); 40hp
Bus (Type 2); 40hp
KG; 40hp
Part #: 111105245
This seal goes behind the flywheel.
Application:Part #: 311105273ARC
These flywheels have been reconditioned and are sold on an exchange basis.
Application:Part #: 1105253RD
This is a crank pulley for an upright motor.
Application:Part #: 311105295A
This seal goes in the flywheel.
Application:
This is a steel gear that goes on the crank to turn the cam.
