Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This is a hub that is keyed onto the generator or alternator to mount the fan.
This is a hub that is keyed onto the generator or alternator to mount the fan. You will need to use generator shims to space the fan out from its backing tin. Place the fan on the hub and hand tighten. Give the fan a spin and make sure it is not bent or hitting the tin. Mount this generator or alternator/fan assembly back into the fan shroud. Now put the belt on, shove your screwdriver in the front pulley and lock up the shaft. With a 36mm socket, reach around the backside of the fan shroud and torque the nut to 45 ft. lb.
Bug (Type 1): All
Bus (Type 2): -67
Ghia: All
Thing: 73-74
Race/Off-Road: All
No customer reviews for the moment.
Part #: 1903109BLT
Black Billet Alternator/Generator Pulley Kit
Application:Part #: 111119123A
Cooling Fan Hub
Application:Part #: 111903131A
Probably the most common cause of generator pulleys coming apart is the shortage of shims.
Application:Part #: 1903109BIL
Billet Aluminum Pulley - 12 volt alt/gen
Application:Part #: SR11X
This is what starts the car.
Application:Part #: JC86020
Jaycee Billet Alternator Pulley, Red
Application:Part #: SR15HT
This is what starts the car.
Application:Part #: 1903109SHIM
Billet Alternator/Generator Pulley Shim Kit (Pack of 5)
Application:Part #: 1903141B
This strap is much stronger than the stock strap, not that you need a super strap to hold the alternator or generator.
Application:Part #: 1903109CH
This is a stock generator pulley that has been chromed.
Application:Part #: SRHT6V
A 6volt gear that fits the high torque starter.
Application:Part #: AL82NC
This unit supplies the battery with voltage.
Application:Part #: 1301103
This bushing is made to mate mismatched bellhousing and starter combinations.
Application:Part #: 1903531
On all upright motor, this plastic cover goes over the top opening of the generator to keep dirt out.
Application:Part #: 111119141A
Cooling Fan Nut
Application:Part #: 1119031BHD
Motors with high horsepower and motors that rev fast run the risk of exploding a stock fan.
Application:
This is a hub that is keyed onto the generator or alternator to mount the fan.
