Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This is the pulley on the generator that holds the belt.
This is the pulley on the generator that holds the belt. When replacing the pulley, make sure you have a total of eight shims. Place the pulley half, with the key way in it, on the generator. Install three shims, the belt and the other pulley half. Now place the other five shims on the generator, then the bell and the nut. Tighten the nut, letting the belt slip and the engine turn. Once the belt has ridden all the way up, use a screwdriver in the slot and tighten the nut. Check the tension of the belt. If it's too loose, take out a shim in the middle and add it to the outside. If it's too tight, add one from the outside to the middle. Note: If you run the belt too tight, you will ruin the bearings in the generator. It is imperative you have a total of eight shims, otherwise you will be throwing pulleys and buying a new generator.
Bug (Type 1): All
Bus (Type 2): All
Type 3: All
Ghia: All
Thing: All
Race/Off-Road: All
No customer reviews for the moment.
Part #: JC86010
Jaycee Billet Alternator Pulley, Black
Application:Part #: 111903137E
This is the belt that turns the generator.
Application:Part #: 1903109POL
Polished Billet Alternator/Generator Pulley Kit
Application:Part #: 111903137D
This is the belt that turns the generator.
Application:Part #: 043903109GR
This is the pulley on the generator that holds the belt.
Application:Part #: 111903181
Generator Pulley Nut
Application:Part #: GR15NCH
Generators supply the battery with voltage. CHINA
Application:Part #: 1903141B
This strap is much stronger than the stock strap, not that you need a super strap to hold the alternator or generator.
Application:Part #: GR11X
Generators supply the battery with voltage.
Application:Part #: SRHT6V
A 6volt gear that fits the high torque starter.
Application:Part #: 1903109CH
This is a stock generator pulley that has been chromed.
Application:Part #: 1903109BLT
Black Billet Alternator/Generator Pulley Kit
Application:Part #: 1903109BORD
Billet Pulley Outer Half Red
Application:Part #: 1903141
This chrome strap holds the alternator or generator to the stand.
Application:Part #: GR11XCO
Generators supply the battery with voltage.
Application:Part #: GR15XCO
Core Charge Generators supply the battery with voltage. Rebuilt
Application:
This is the pulley on the generator that holds the belt.
