Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
Generators supply the battery with voltage. To test a 12v generator, take the wires off the D+ and the DF terminals. Grab a volt meter and hook up the volt meter so the positive lead goes to the D+ and the negative to the DF. Now run a jumper wire from the DF to the D-. Start the car and rev the motor. If the meter pegs, the generator is good and if it doesn't, then it's bad. Now if the meter jumps to lower voltage the generator may need to be polorized. To polorize a generator, make sure the voltage regulator wires are still disconnected. Take off the generator belt. Using a battery with jumper cables, hook up the positive to the D+ and the negative to D-. Now with a jumper wire, go from the DF to the body of the generator. Hold the wire there just long enough to see the generator spin like a motor; no longer, or you will burn up the generator. Some generators are sold on exchange.
Type 3: 67-73
No customer reviews for the moment.
Part #: 1301104
This bushing is made to mate mismatched bellhousing and starter combinations.
Application:Part #: SR11XCO
This is what starts the car.
Application:Part #: 1903109RD
Billet Alt/Gen Pulley Red
Application:Part #: SRHT6V
A 6volt gear that fits the high torque starter.
Application:Part #: 1903109BL
Billet Alt/Gen Pulley Blue
Application:Part #: JC86010
Jaycee Billet Alternator Pulley, Black
Application:Part #: 111903221A
These are the bearings and brushes for your generator.
Application:Part #: N127051
This is the pulley on the generator that holds the belt.
Application:Part #: 111903181
Generator Pulley Nut
Application:Part #: 1903109BLT
Black Billet Alternator/Generator Pulley Kit
Application:Part #: 1301103
This bushing is made to mate mismatched bellhousing and starter combinations.
Application:Part #: 1903531
On all upright motor, this plastic cover goes over the top opening of the generator to keep dirt out.
Application:Part #: 1903109BOBL
Billet Pulley Outer Half Blue
Application:Part #: SR17X
This is what starts the car.
Application:Part #: 1903109BOPO
Billet Pulley Outer Half Polished
Application: