Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This is what starts the car.
This is what starts the car. It usually quits the furthest place from home. To bench test a starter is tough, as they can work but are weak. In other words, it will work on the bench, but as soon as it has the drag of the engine on it, it won't. The way we test starters is in the car with a remote starter button (a push button with two long wires). Disconnect the battery. Hook up one of the wires to the big post that the battery cable is hooked to and the other wire to where the push-on wire is located. Now connect the battery back up and make sure the E-brake is on and the car is out of gear. Push the remote starter button. If the engine turns over the starter is good, and if it doesn't, it's bad. If you find the starter works with the remote starter but not with the key, call us. You might need a hard start relay or a new electrical part in the ignition switch. Some starters are sold on exchange.
Bug (Type 1): 68-
Bus (Type 2): 72-83
Type 3: 68-
Ghia: 68-
No customer reviews for the moment.
Part #: 111903221A
These are the bearings and brushes for your generator.
Application:Part #: 30019
This little box tells the generator what to do.
Application:Part #: 1301104
This bushing is made to mate mismatched bellhousing and starter combinations.
Application:Part #: SR11XCO
This is what starts the car.
Application:Part #: N127051
This is the pulley on the generator that holds the belt.
Application:Part #: 113903515
These are the bearings and brushes for your generator.
Application:Part #: SR17XCO
This is what starts the car.
Application:Part #: 1903183
This aftermarket chrome cap nut and spacer hold the alternator/generator pulley on.
Application:Part #: SR11X
This is what starts the car.
Application:Part #: 043903109BR
This is the pulley on the generator that holds the belt.
Application:Part #: 113971901A
This boot goes over the wire and the terminal of the generator or alternator.
Application:Part #: 111903515A
These are the bearings and brushes for your generator.
Application:Part #: 211903183
This is the bell shaped spacer that hold the outer half of the generator pulley on.
Application:Part #: JC86000
Jaycee Billet Alternator Pulley, Blue
Application:Part #: 111903137E
This is the belt that turns the generator.
Application:Part #: 30049
This little box tells the alternator what to do. This is a german one but is not Bosch
Application:
This is what starts the car.
