Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These locks keep the vent wing closed, therefore a must, but they're a pain to replace.
These locks keep the vent wing closed, therefore a must, but they're a pain to replace. Start by removing the glass and rubber. Use a 1/8" drill and drill out the original rivets. Next, remove whatever is left of the old lock and install the new lock. Using 1/8" pop rivets, install the head of the lock from the frame side. With a hammer and dolly, very carefully flatten what's left of the rivet on the latch side. Now replace the glass and rubber.
Bug (Type 1): right,52-64, Conv.,52-67
Bus (Type 2): left,54-67
Race/Off-Road: right,52-64
No customer reviews for the moment.
Part #: JC43630
Jaycee T1 Racer Linkage, Red
Application:Part #: 141837475C
Outside Scraper, Rubber Only
Application:Part #: 113611829A
Master Cylinder to Bulkhead Spacer
Application:Part #: 111701535A
Accelerator Pedal Bracket
Application:Part #: 113857219A
These are the clips that hold the various chrome moldings on. Sold each
Application:Bug (Type 1); Chrome molding seal 1950-1966, Door panel clip seal All
Ghia; All
Type 3; All
Off road: All
Part #: 211611741B
These are the metal brake lines found throughout the car.
Application:Part #: F1102
These are the glues and oils we use..
Application:Part #: 6857651
Billet Deluxe Whip Antenna Mount for 1.75" Tubing
Application:Part #: 1251201
When you upgrade to dual carburetors, use these plates to block off the heat risers on your headers or stock exhaust system.
Application:Part #: 113105281A
These shims set the endplay of the crankshaft.
Application:Part #: 311251061F
This is the exhaust silencer.
Application:Part #: 1415802B
This is a great way to dress up the front end of your car.
Application:Part #: 1109460
These shims are used under the rockers to set the geometry.
Application:Part #: 211298055
This kit includes the gaskets and hardware to install a stock muffler or tail pipes..
Application:Part #: 113611775E
This flex hose goes from the metal brake line on the rear fork to the metal brake line on the axle tube.
Application:Part #: 117867500
This is the vinyl covering for the inside roof and sides of the Bug.
Application:
These locks keep the vent wing closed, therefore a must, but they're a pain to replace.
