Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This is the tube that goes through the fan shroud that the accelerator cable threads through.
This is the tube that goes through the fan shroud that the accelerator cable threads through. We usually put a 10mm flat washer on it, then stick it through the shroud. On the backside of the shroud, use a fuel line hose clamp on the tube to keep it from pulling back through the shroud.
Bug (Type 1): All
Bus (Type 2): All
Ghia: All
Offroad: All
No customer reviews for the moment.
Part #: 113129909
This is the clip for the tube that goes through the fan shroud that the accelerator cable threads through.
Application:Part #: 113129905
This is the tube that goes through the fan shroud that the accelerator cable threads through.
Application:Part #: 113129901
This is the tube that goes through the fan shroud that the accelerator cable threads through.
Application:Part #: 311943169A
Wire to License Light Assembly Boot
Application:Part #: 211809201
"A" Post Repair Section, Left
Application:Part #: 311943131
This is the lens and seal for the light that shines on the license plate.
Application:Part #: 261813163
This is what the battery sits on.
Application:Part #: 111941037CQ
This is the bucket that the bulb fits into.
Application:Part #: 221883861A
When you mount the middle seat, you'll want the rubber mat down and the bolts in the key slots first.
Application:Part #: 113415801
These two rods go from the center pin on a Bus or the pitman arm on a Bug, to the spindles, making the car turn.
Application:Part #: 143845211
These seals slide into a channel sealing the front door window glass on a Ghia.
Application:Part #: 113129415B
Here are some of the replacement parts for your stock carburetor. Sold individually.
Application:Part #: 1823566
This guard goes underneath the front hood handle to prevent your fingernails from scratching the paint..
Application:Part #: 261813300
Truck Corner Louver Section
Application:Part #: 131415811
These are the ball joints on the tie rods.
Application:Part #: 2251007
We like to run EMPI deluxe headers because they have the best fit, as well as, a good merge on the collector.
Application:Part #: 1883405CU
Like the custom door panels these car seat covers are a great way to customize the interior of your Bug.
Application:Part #: 1127106ALM
This is stainless steel braided fuel line.
Application:Part #: 6517283
These conversion flanges will allow you to run bigger stronger Bus or 930 CV joints..
Application:
This is the tube that goes through the fan shroud that the accelerator cable threads through.
