Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
The front door window rolls up and down between these two rubber seals.
The front door window rolls up and down between these two rubber seals. The outer scraper is very important because it keeps water out of the door, it's also the "most fun" to put in. No kidding; installing these seals are a real chore. Start by gutting the door. When installing these seals, check the little drain holes in the bottom of the door to make sure they're clear. Note: We found the old clips that hold the scrapers in are much better then the new clips they come with.
Bug (Type 1): 65-68
Off-Road: 65-68
No customer reviews for the moment.
Part #: 1101441
This is a shim that is used between the head and barrel.
Application:Part #: 211405371A
These joints are located in the ends of the control arms.
Application:Part #: 111953675
SHO and SWF Brand Semaphore Power Wire Screw
Application:Part #: 311863402
Carpet kit.
Application:Part #: 1601057
Empi Corsa, Gun Metal Grey w/ Polished Lip, 5x205, 15x5.5"
Application:Part #: 6129651BK
Outerwear pre-filters feature a patented; Micro Mesh nylon filtration system that stops sand and dirt before it gets to your air cleaner element.
Application:Part #: 211721383B
These seals go around the shafts of the clutch and brake pedal to seal the holes in the floor.
Application:Part #: 1127109
This is a brass tee for dual carbs.
Application:Part #: 261801465A
This is a section of the rear cargo bed of a truck.
Application:Part #: 111301257
Transmission Horn Bolt
Application:Part #: 1405075
Replacement Brake Rotor Double Drilled 5x130mm and 5x4.75"
Application:Part #: 1119023
This spacer kit uses 1 1/4" thick aluminum spacers to close the gap between the fan shroud and the cylinder tins where the sheet metal screw attaches.
Application:Part #: 1109641
If you are going to run dual springs we suggest you use these valve spring retainers as well.
Application:Part #: 311698151B
These brake pads go into the calipers and are sold in sets of four; two per caliper.
Application:Part #: 113415660A
Turn Signal Cancelling Ring
Application:Part #: 6415811C
Tapered Chromoly Bung, mainly used for fabricating Tie Rods on Offroad/Race Applications. Thread 7/8"-14 LH
Application:
The front door window rolls up and down between these two rubber seals.
