Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These rods link the cam to the valves.
These rods link the cam to the valves. If you have used rods, make sure that they are straight by rolling them on a flat surface. Inspect the ends and blow air through the tip making sure it comes out the other side. We do not recommend using steel push rods on a daily driver, because the expansion rate is different and requires you to adjust the valves more often. Note: When installing push rods, squirt some oil on the ends and down the hole. Sold each
No customer reviews for the moment.
Part #: 1109623
These are single heavy duty valve springs which are used on engines with Engle 110 or larger cams.
Application:Part #: 043109451
This screw rides against your valve, opening and closing it.
Application:Part #: JC91030
Jaycee Leak proof Pushrod Tubes, Blue
Application:Part #: 1109451
This style of adjusting screw has a ball with a flat side on the end.
Application:Part #: 1109601
These caps go on the ends of the valve.
Application:Part #: 113101401
If you're rebuilding your own heads, you will probably need guides.
Application:Part #: 311109601
The two inside valves in the head are the intake valves, which let the gas into the combustion chamber.
Application:Part #: N111521
This screw rides against your valve, opening and closing it.
Application:Part #: 113109021GBR
We've had no luck with regrinds, therefore we sell only new camshafts.
Application:Part #: 1109605
Stainless steel valves are used in the big valve heads.
Application:Part #: 1109401125SC
1.25 Ratio Rockers Pro SCAT
Application:Part #: 113109345A
These are the seals that go around the push rod tubes.
Application:Part #: 1109401125
Rocker Arms, High Ratio 1.25, w/Bushing, Set
Application:Part #: 1109612
Stainless steel valves are used in the big valve heads.
Application:Part #: 111198541HD
The cam rides in these bearings.
Application:Part #: 1109461
These shims are used under the rockers to set the geometry.
Application:
These rods link the cam to the valves.
