Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This pin and its bushings are housed on the front side of the front axle beam in a box.
This pin and its bushings are housed on the front side of the front axle beam in a box. To check for wear, have a friend turn the steering wheel back and forth while you place your hand on the top of the arm that is attached on the pin. If you feel the arm moving up and down before it spins then it needs to be replaced. On buses up to 1967 the new bushing will need to be reamed to size, once installed. We can rent you a tool that makes this job real easy on all busses to 1979. Note: If you are going to install these with out the tool it is very important that the bottom bushing be pressed in flush and the top bushing stick out .040".
Bus (Type 2): 55-67
No customer reviews for the moment.
Part #: 211837375A
The front door windows slide in the felt channels.
Application:Part #: 1101131B
A case saver is an insert that repairs worn or stripped head stud holes in a case.
Application:Part #: 113109345A
These are the seals that go around the push rod tubes.
Application:Part #: 002141701
This shaft holds the throw-out bearing in place.
Application:Part #: 2863620W
This handy basket hangs from the vent slots to allow you to finally have the cup holder you've always dreamed of. The front spring loaded pocket is a nice place to store your cell phone, or maybe to hold your registration for when the cops pull you over for going too slow. Available in black and white.
Application:Part #: 211857550
Visor and Rearview mirror mounting screws
Application:Part #: 022101361C
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld).
Application:Part #: 1115450PL
The oil filler extension screws into the generator stand and comes with a fitting to vent the crankcase.
Application:Part #: 6905811
If you want a keyed ignition switch for you buggy or tube car, here you go.
Application:Part #: 211798001
Accelerator Pedal Repair Kit
Application:Part #: 211611313K
Brake Fluid Reservoir for Servo Assisted Braking system 85mm/3.34" hole spacing
Application:Part #: 021119957
Oil Pressure switch boot
Application:Part #: JC86060
Jaycee Billet 7" Crank Pulley for Street Cars, Blue
Application:Part #: 151863122
These are the interior panels.
Application:Part #: 111801046K
The heater channel carries heat form the heater boxes to the front of the car.
Application:
This pin and its bushings are housed on the front side of the front axle beam in a box.
