Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:This hydraulic cylinder feeds all the wheel cylinders.
This hydraulic cylinder feeds all the wheel cylinders. After installing a new one make sure the rod that pushes the plunger is adjusted correctly. When adjusting it you can't see the measurement but you can feel it. The rod should have about an 1/8" of free play before it starts pushing. If it's too tight it will not allow the fluid to travel back to the reservoir locking up the brakes usually in the middle of an intersection.
No customer reviews for the moment.
Part #: 191611349A
This cap sits on the top of the brake fluid reservoir filler hole.
Application:Part #: 113611373
This cap sits on the top of the brake fluid reservoir filler hole.
Application:Part #: 211611301CM
The reservoir holds the brake fluid for the brake master cylinder.
Application:Part #: 113611195
This boot is on the plunger end of the master cylinder, keeping dirt out of the master cylinder..
Application:Part #: 211611351B
Brake Fluid Reservoir Cap, Plastic
Application:Part #: 021198175A
Rings on the pistons are there to eliminate "blow-by".
Application:Part #: 311971907
Turn Signal Switch Grommet for Type 1, fuel pump and backup harness grommet on late Type 2, and main harness through body early Type 2
Application:Part #: 133415303
These two rods go from the center tie rod on a Bug, to the spindles, making the car turn.
Application:Part #: 1415801A
This is a great way to dress up the front end of your car.
Application:Part #: 1117023FAN
This is the same as the mesa cooler but with a fan mounted to it.
Application:Part #: 111809132
Front Bumper Mount, Right
Application:Part #: 211883405
Like the door panels, seat covers are a long subject; so here's the basics.
Application:Part #: JC86200
Jaycee Billet 5.5" Crank Pulley for Drag Cars, Red
Application:Part #: 112920228
28mm Main Venturi for 40/44 HPMX (EMPI), 44 IDF (WEBER)
Application:Part #: 111398003
Transmission gasket set.
Application:Bug (Type 1); -60
Bus (Type 2); -59
Ghia; -60
Part #: 113863707
This is a full carpet kit.
Application:Part #: 1251014SS
Stainless Steel Phat Boy Muffler for Merged Exhaust
Application:Part #: 211857501H
Interior Rear View Mirror
Application:Part #: 211945351A
This plastic bulb holder fits on the side in the rear..
Application:Part #: 1129627
CB 650 Dual Valve Springs (Set)
Application:Part #: 111953619
SWF Brand Semaphore Lens Screw
Application: