Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These shims are used with the Solid Shaft Rocker Kit.
These shims are used with the Solid Shaft Rocker Kit. Even though the rocker kit comes with shims, you many need more. When you run solid shafts, it's very important they are shimmed correctly.
No customer reviews for the moment.
Part #: 113109021DBR
We've had no luck with regrinds, therefore we sell only new camshafts.
Application:Part #: 113109651A
These springs return the valves back to their seats.
Application:Part #: 1109002
Premium Performance Aftermarket Cam Gear
Application:Part #: 1109415
These shims are used under the rockers to set the geometry.
Application:Part #: 1109651
We have had good luck with stock keepers on single springs.
Application:Part #: 1109338
These push rod tubes are spring loaded and are great for replacing bent tubes without having to pull the head(s) off.
Application:Part #: 111109335
These tubes go from the case to the heads to house the push rods.
Application:Part #: 1109006
These gears give just a hair more horsepower.
Application:Part #: 1109401125SC
1.25 Ratio Rockers Pro SCAT
Application:Part #: 1109601
These caps go on the ends of the valve.
Application:Part #: 111109345
Push Rod tube seal for 36 HP
Application:Part #: N111521
This screw rides against your valve, opening and closing it.
Application:Part #: 1109603
Stainless steel valves are used in the big valve heads.
Application:Part #: 111198541HD
The cam rides in these bearings.
Application:Part #: 11310140102
If you're rebuilding your own heads, you will probably need guides.
Application:Part #: 1109302
These push rods are made out of chromoly steel and do not expand at the same rate as aluminum.
Application:
These shims are used with the Solid Shaft Rocker Kit.
