Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
On Bugs up to 1967 and on Buses up to 1963 you will need to push back the small plastic bezel.
On Bugs up to 1967 and on Buses up to 1963 you will need to push back the small plastic bezel. You will see a pin coming in from the side. Use a small punch or a nail with the head removed to drive the pin out. We suggest you do this in a clean area because the pin usually flies out and you will want to be able to find it. Once the pin is out, wiggle the handle and it will come off. On 1968 and later cars, you will need to pry out the plastic cover that is over the handle. Behind it you will need to remove the phillips screw. The handles that fit the Vanagon (#321 837 581) will work on the 68 and later Bugs, Buses and Type 3's and are a heavier duty than the stock one.
Bug (Type 1): 68-79
Bus (Type 2): 68-79
Type 3: 68-74
Ghia: 68-74
Race/Off-Road: 68-79
No customer reviews for the moment.
Part #: 211611301CM
The reservoir holds the brake fluid for the brake master cylinder.
Application:Part #: 6105247
There are two types of sand seals.
Application:Part #: 211809163A
Rear Wheel Well Arch, Left
Application:Part #: SR87XCO
This is what starts the car.
Application:Part #: 211501273A
This gasket goes between the reduction box halves.
Application:Part #: 211711630C
Heater cables open the flaps in the heater boxes allowing heat into the car.
Application:Part #: T1511205
This is the only way to correctly set your spring plates.
Application:Part #: 111511245E
This rubber "donut" goes around the spring plate, allowing it to move up and down.
Application:Part #: 211611775B
This flex hose goes from the metal brake line on the rear fork to the metal brake line on the axle tube.
Application:Part #: 043129617A
Air Intake Boot for Fuel Injection
Application:Part #: 311927147B
Neutral safety switch
Application:Part #: 6251010CH
Systems are designed for max horsepower and to handle the punishment of off-road competition.
Application:Part #: 211611805H
Brake tube
Application:Part #: 1611750C
These stainless steel braided flex lines don't swell like the original rubber hoses and they make the undercarriage look a lot nicer.
Application:Part #: 141827705A
This is the seal that goes around the rear deck lid.
Application:Part #: 1198036
If you are converting a single port engine to a dual port or if you have a brand new case; these are the head studs you're looking for.
Application:
On Bugs up to 1967 and on Buses up to 1963 you will need to push back the small plastic bezel.
