Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N109052
Screws for replacement pop out window frames. These screws are for joining the two Popout frame halves together
Application:This is a replacement shift rod.
This is a replacement shift rod. They rarely go bad. See SHIFT ROD BUSHINGS for details to put one in.
Bug (Type 1): 73-79
Type 3: 73-74
Ghia: 65-74
Thing: 73-74
Race/Off-Road: 73-79
No customer reviews for the moment.
Part #: 1711176
This coupler joins the shift rods.
Application:Part #: 111701255B
The shift rod guide holds the shift rod bushing.
Application:Part #: 111701263
This bushing wraps around the front shift rod.
Application:Part #: 111701259A
This bushing wraps around the front shift rod.
Application:Part #: 133415801
These two rods go from the center tie rod on a Bug, to the spindles, making the car turn.
Application:Part #: 1857513
These mirrors come in a black housing with a blue non-glare glass or clear glass.
Application:Part #: 113853555D
These are the correct trim moldings for your running boards.
Application:Part #: 251419831A
These are the boots for the rack and pinion units.
Application:Part #: 1129506IDA
Velocity Stack Covers, for 48IDA/EPC 48 & EPC 51 Carbs, Pair
Application:Part #: 143853367
Bottom Quarter Window post Seals (Pair)
Application:Part #: 113611817
This is the grommet for the reservoir line(s) where they go into the master cylinder. 17.5mmx4.5mm
Application:Part #: 111823731
This is the seal that goes on the body for the front hood to sit on.
Application:Part #: 002301241A
This plastic ball goes in the nose cone of a 68-79 bus transmission.
Application:Part #: 251615124CCO
Front calipers hold the brake pads that stop the rotor, which in turn stops your vehicle.
Application:Part #: 211813356D
Rear Corner to Roof, Right
Application:Part #: 1129505007
These are some of the most common jets used.
Application:Part #: 1511245
These grommets go on the spring plates in the torsion housing of your car.
Application:Part #: 113415315
The main reason to replace these clamps is because you've destroyed the old ones getting them off.
Application:Part #: 211259157A
Fresh Air Flap Seal
Application:Bus (Type 2); 68-79