Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N109052
Screws for replacement pop out window frames. These screws are for joining the two Popout frame halves together
Application:These are the gaskets used between the intake manifold and the cylinder head.
These are the gaskets used between the intake manifold and the cylinder head. We prefer using paper gaskets on dual port motors. If for any reason you take off the intake manifold, you will need to replace these gaskets. Note: If you have a single port engine, tighten the heat risers before you tighten the intake at the ports.
Bug (Type 1): 1500-1600
Bus (Type 2): 1500-1600
Type 3: 1500-1600
Ghia: 1500-1600
Race/Off-Road: 1500-1600
No customer reviews for the moment.
Part #: 113129701K
Single Port, Intake Manifold, 1500-1600cc, 30mm Base
Application:Part #: VCP25
This is a rubber plug that is used to plug off vacuum.
Application:Part #: 1129601
This is a replacement air cleaner for the Weber IDF.
Application:Part #: 1127108ALF
This is stainless steel braided fuel line.
Application:Part #: 111127591
Fuel Line Grommet 6mm
Application:Part #: 043133241
These two boots connect the intake manifold with the end casting on a stock dual port 1600cc engine.
Application:Part #: 113127025D
These stock pumps pump fuel into the carburetor.
Application:Part #: 1127022BK
Billet Fuel Pump Block off, Black
Application:Part #: VCP18
This is a rubber plug that is used to plug off vacuum.
Application:Part #: 1129709
This pair of aluminum end castings are for use with a center section manifold.
Application:Part #: 111127591A
Fuel Line Grommet 8mm
Application:Part #: 1129611EL
This is a good, cheap dual carburetor kit for a 1600cc motor.
Application:Part #: 1129608EL
This air cleaner takes the place of a stock air cleaner.
Application:Part #: 1129609EL
This air cleaner takes the place of a stock air cleaner.
Application:Part #: 111127541A
6mm Fuel Line Union Nut
Application:Part #: 1129729RD
These boots are better than stock.
Application: