Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These are the gaskets used between the intake manifold and the cylinder head. We prefer using paper gaskets on dual port motors. If for any reason you take off the intake manifold, you will need to replace these gaskets. Note: If you have a single port engine, tighten the heat risers before you tighten the intake at the ports.
Bus (Type 2): 1700-2000
No customer reviews for the moment.
Part #: 111127531
8mm Fuel Line Ferrule
Application:Part #: 1129601HD
This is a replacement air cleaner for the Weber IDF.
Application:Part #: 1129604EL
This air cleaner takes the place of a stock air cleaner.
Application:Part #: 2129702
We have found this kit to be a good, cheap dual carb kit for a stock motor.
Application:Part #: 113127025G
These stock pumps pump fuel into the carburetor.
Application:Part #: 113127025D
These stock pumps pump fuel into the carburetor.
Application:Part #: 021129637F
We usally find these fittings all taped or glued up.
Application:Part #: 1129601HD6
This is a replacement air cleaner for the Weber IDF.
Application:Part #: 1127025A
This electric pump replaces your stock pump.
Application:Part #: 1127100
Hose Clamp for 5mm hose
Application:Part #: 1129025
This is a new aftermarket UNIVERSAL intake manifold for Dual Port Engines. You can use a 30 Pict1 or 34Pict3 Carburetor. We have had major icing problems with this part and prefer stock manifolds.
Application:Part #: 311133261A
These o-rings should be replaced whenever you replace a fuel injector, or if they are old and cracked.
Application:Part #: 1127022RD
Billet Fuel Pump Block off, Red
Application:Part #: 1129708
This pair of aluminum end castings are for use with a center section manifold.
Application:Part #: 113127303
The fuel pump sits on this little stand and it's also the guide for the push rod.
Application:Part #: 1127110
This is a brass tee for dual carbs.
Application:
