Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This hose adapter takes the place of the stock oil filter and allows you to run external oil coolers.
This hose adapter takes the place of the stock oil filter and allows you to run external oil coolers. What you would do is run the hoses out of this adapter to a remote filter adapter and cooler. A good way to go on type 4 engines. Fits all buses 72-79.
Bus (Type 2): 1700-2000
No customer reviews for the moment.
Part #: 1117008
This adapter is used to mount an oil filter either by itself or in line with an oil cooler.
Application:Part #: 021198031
These gaskets are used on the sump plates of the engine.
Application:Part #: JC22250
Jaycee Billet Oil Cap with Breater -10 AN Fitting, Red
Application:Part #: JC22960
Jaycee Billet Full Flow Pump Cover w/ -8 O-ring Fitting, Blue
Application:Part #: 1115465
This air filter is made to protect the crankcase.
Application:Part #: 070115311
It caps the hole you are aiming at while pouring oil over everything else.
Application:Part #: 1117108ALF
These fittings are used for the stainless steel hose.
Application:Part #: 111115451
This rubber collar goes around the dump tube that comes from the generator stand.
Application:Part #: 1117109
This block off plate is made to loop the oil back into the case in place of the stock oil cooler.
Application:Part #: 021115421B
Oil Pressure Relief Spring
Application:Part #: 1115452
This stock oil filler and cap has been chromed.
Application:Part #: 113117021
This stock oil cooler cools the hot oil coming from the engine.
Application:Part #: 1115450PL
The oil filler extension screws into the generator stand and comes with a fitting to vent the crankcase.
Application:Part #: 1117699
When mounting the oil cooler above the transmission on a Bug, Type 3, Ghia, Thing, or Off Road car you can use these rubber mounted studs.
Application:Part #: 1117108
When plumbing the oil filter, oil cooler and/or case, these are the fittings you will need.
Application:Part #: 111117151
This stock oil cooler cools the hot oil coming from the engine.
Application:
This hose adapter takes the place of the stock oil filter and allows you to run external oil coolers.
