Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This boot goes on the end of the dump tube.
This boot goes on the end of the dump tube. It has a valve (or slice) in the end allowing oil pressure to vent out but nothing to get in. Many people don't realize the importance of this little rubber boot. When you are starting the engine, the tube will suck air and this boot keeps the dirt out. Note: When installing the boot, dip your finger in oil and smear it on the inside of the boot. Shove it on until the little nub on the inside finds the hole in the tube, no clamp is needed.
Bug (Type 1): 60-73
Bus (Type 2): 60-71
Ghia: 60-73
Thing (Type 5): 73
No customer reviews for the moment.
Part #: 1115485CH
A stock cap that has been chromed for looks..
Application:Part #: 1115464
This air filter is made to protect the crankcase.
Application:Part #: 1117698
When mounting the oil cooler above the transmission on a Bug, Type 3, Ghia, Thing, or Off Road car you can use these rubber mounted studs.
Application:Part #: 1115107FF
30mm Oil pump for Dual Relief & Flat cam Full Flowed Engines
Application:Part #: 1119031
Replacement fan
Application:Part #: JC21030
Jaycee Mag-Plate, 6 Bolt, Blue
Application:Part #: 1115422
These stronger springs were designed to boost the oil pressure in your motor.
Application:Part #: 111117151
This stock oil cooler cools the hot oil coming from the engine.
Application:Part #: 111115451
This rubber collar goes around the dump tube that comes from the generator stand.
Application:Part #: 021117151A
This stock oil cooler cools the hot oil coming from the engine.
Application:Part #: JC22960
Jaycee Billet Full Flow Pump Cover w/ -8 O-ring Fitting, Blue
Application:Part #: N115244
This is a general rule for washer use, wafer washers are used against aluminum and lock washers are used against steel..
Application:Part #: 021115311
It caps the hole you are aiming at while pouring oil over everything else.
Application:Part #: 111115495
This is more of a bolt than a nut.
Application:Part #: 1115458
The smooth flow design has a nice look and comes with a knurled cross-groove or smooth billet grooved cap for a good grip when it is wet or oily.
Application:Part #: N110062
Some of the more common nuts you might need..
Application:
This boot goes on the end of the dump tube.
