Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These are the two pieces of tin that attach to a doghouse style fan shroud.
These are the two pieces of tin that attach to a doghouse style fan shroud. They duct the hot air out the back of the shroud and onto the ground. Having a doghouse shroud does you no good without these in place. A tight fit here is real important, so make sure it seals properly.
No customer reviews for the moment.
Part #: 1119526CH
This tin goes from one piece of cylinder tin to the other.
Application:Part #: 1119025BK
This style fan shroud combines the small shroud of the 36hp and the later doghouse style shroud.
Application:Part #: 1119025BKS
Super Shroud, Dog house oil cooler style, with heater ducts, black
Application:Part #: 1119025CH
This style fan shroud combines the small shroud of the 36hp and the later doghouse style shroud.
Application:Part #: 131119357
These are the short pieces that fit under the big cylinder tin towards the crank pulley.
Application:Part #: 1119352CH
These three pieces of tin go from the heater boxes to the case.
Application:Part #: N115244
This is a general rule for washer use, wafer washers are used against aluminum and lock washers are used against steel..
Application:Part #: 1119302BK
These cylinder head tins sit under the fan shroud.
Application:Part #: 1119527CH
This tin goes from one piece of cylinder tin to the other.
Application:Part #: 1119023
This spacer kit uses 1 1/4" thick aluminum spacers to close the gap between the fan shroud and the cylinder tins where the sheet metal screw attaches.
Application:Part #: 1119527BK
This tin goes from one piece of cylinder tin to the other.
Application:Part #: 113119317
These are also known as the "forget-me-nots".
Application:Part #: 043119350B
Heater Channel Tin Upper Right
Application:Part #: 1119026CH
This style fan shroud combines the small shroud of the 36hp and the later doghouse style shroud.
Application:Part #: 1119528CH
This tin goes from one piece of cylinder tin to the other.
Application:Part #: 1119525BK
This tin goes from one piece of cylinder tin to the other.
Application:
These are the two pieces of tin that attach to a doghouse style fan shroud.
