Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This small fan shroud came on the 36hp motor.
This small fan shroud came on the 36hp motor. The nice thing about this shroud is that it gives you more room around dual carberators. This shroud is okay, but we prefer the doghouse shroud, because it's a better cooling system. Also the stock internal oil cooler does not fit in this shroud.
Bug (Type 1): 40hp-1600
Bus (Type 2): 40hp-1600
Ghia: 40hp-1600
Thing: 40hp-1600
Race/Off-Road: 40hp-1600
No customer reviews for the moment.
Part #: 1119025CH
This style fan shroud combines the small shroud of the 36hp and the later doghouse style shroud.
Application:Part #: 1117323
Hoover Bit
Application:Bug (Type 1); 1600
Bus (Type 2); 1600
KG; 1600
Thing; 1600
Offroad/race car; 1600
Part #: 1119028BK
This small fan shroud came on the 36hp motor.
Application:Part #: 1119526BK
This tin goes from one piece of cylinder tin to the other.
Application:Part #: 1119303BK
These cylinder head tins sit under the fan shroud.
Application:Part #: 113119031B
This is the fan that fits inside of the fan shroud on Bugs 1971-1979 and a 1971 Bus.
Application:Part #: 1119525CH
This tin goes from one piece of cylinder tin to the other.
Application:Part #: 1119027CH
This small fan shroud came on the 36hp motor.
Application:Part #: 1119526CH
This tin goes from one piece of cylinder tin to the other.
Application:Part #: 1119023
This spacer kit uses 1 1/4" thick aluminum spacers to close the gap between the fan shroud and the cylinder tins where the sheet metal screw attaches.
Application:Part #: 131119358
These are the short pieces that fit under the big cylinder tin towards the crank pulley.
Application:Part #: 1119527CH
This tin goes from one piece of cylinder tin to the other.
Application:Part #: 1119517BK
This piece of tin goes behid the engine towards the flywheel and screws down to the cylinder tins.
Application:Part #: 1119516CH
This piece of tin goes behid the engine towards the flywheel and screws down to the cylinder tins.
Application:Part #: 1903032
These are the three pieces of tin that go on the back of the generator or alternator.
Application:Part #: 1903031CH
This is one of the three-pieces of the Alternator or Generator Tin Set, it's the large flat plate that is seen.
Application:
This small fan shroud came on the 36hp motor.
