Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These push rod tubes are spring loaded and are great for replacing bent tubes without having to pull the head(s) off.
These push rod tubes are spring loaded and are great for replacing bent tubes without having to pull the head(s) off. However, they should be used only in an emergency, as they do leak a little. We found the stock push rod tubes are the best.
Bug (Type 1): 40hp-1600
Bus (Type 2): 40hp-1600
Type 3: 40hp-1600
Ghia: 40hp-1600
Thing: 40hp-1600
Race/Off-Road: 40hp-1600
No customer reviews for the moment.
Part #: 1109002
Premium Performance Aftermarket Cam Gear
Application:Part #: 1109451
This style of adjusting screw has a ball with a flat side on the end.
Application:Part #: 1109000
Engle cams are one of the most popular performance camshafts made for the air-cooled Volkswagen.
Application:Part #: JC91010
Jaycee Leak proof Pushrod Tubes, Red
Application:Part #: 1109430
These shims are used under the rockers to set the geometry.
Application:Part #: JC91000
Rebuild kit for Jaycee Leak proof Pushrod Tubes
Application:Part #: 111101401B
If you're rebuilding your own heads, you will probably need guides.
Application:Part #: 11310140105
If you're rebuilding your own heads, you will probably need guides.
Application:Part #: 113109301D
These rods link the cam to the valves. These are very costly so please call for good used ones.
Application:Part #: N111521
This screw rides against your valve, opening and closing it.
Application:Part #: 113109601B
The two inside valves in the head are the intake valves, which let the gas into the combustion chamber.
Application:Part #: 043109451
This screw rides against your valve, opening and closing it.
Application:Part #: 111109335
These tubes go from the case to the heads to house the push rods.
Application:Part #: 1109642
If you are going to run dual springs we suggest you use these valve spring retainers as well.
Application:Part #: 1109002USA
Cam Gear without bolts USA Made
Application:Part #: 1109651
We have had good luck with stock keepers on single springs.
Application:
These push rod tubes are spring loaded and are great for replacing bent tubes without having to pull the head(s) off.
