Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These ride against the cam. Sold each. You will need 8 to do an engine
These ride against the cam. We prefer the Engle brand that have been coated. We personally have had bad luck with regrinds. If you are going to use used ones, clean the head surfaces and put two together with the faces touching. Hold them up to a light to see if you can see light between them increasing from the middle out. In other words the heads should be convex not concave or flat. Note: When installing, make sure your cam has .060 to .100" clearance from the top of the cam lobe to the lifter. Install using cam assembly lube. Sold each you will need 8 to do an engine
Bug (Type 1): 40hp-1600
Bus (Type 2): 40hp-1600
Type 3: 40hp-1600
Ghia: 40hp-1600
Thing: 40hp-1600
Race/Off-Road: 40hp-1600
No customer reviews for the moment.
Part #: 111198541GR
The cam rides in these bearings.
Application:Part #: 1109302
These push rods are made out of chromoly steel and do not expand at the same rate as aluminum.
Application:Part #: 1109451
This style of adjusting screw has a ball with a flat side on the end.
Application:Part #: 1109612
Stainless steel valves are used in the big valve heads.
Application:Part #: JC91040
Jaycee Leak proof Pushrod Tubes, Silver
Application:Part #: 1109305
Aluminum Smith Bros. Push Rods
Application:Part #: 1109406
These shims are used with the Solid Shaft Rocker Kit.
Application:Part #: 11310140102
If you're rebuilding your own heads, you will probably need guides.
Application:Part #: 1109010
Engle cams are one of the most popular performance camshafts made for the air-cooled Volkswagen.
Application:Part #: 113109301D
These rods link the cam to the valves. These are very costly so please call for good used ones.
Application:Part #: 1109335
These stock-style tubes are made of stainless steel.
Application:Part #: 043109611A
The two outside valves in the head are the exhaust valves, they let the burned fuel out of the head.
Application:Part #: 1109000
Engle cams are one of the most popular performance camshafts made for the air-cooled Volkswagen.
Application:Part #: 1109398
These rocker studs are much stronger than the stock studs and are .100" longer to allow more flexibility when setting your rocker arm geometry..
Application:Part #: 1109651
We have had good luck with stock keepers on single springs.
Application:Part #: 1109399
1.25 Ratio Rockers ONLY
Application:
These ride against the cam. Sold each. You will need 8 to do an engine
