Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These rods link the cam to the valves.
These rods link the cam to the valves. If you have used rods, make sure that they are straight by rolling them on a flat surface. Inspect the ends and blow air through the tip making sure it comes out the other side. We do not recommend using steel push rods on a daily driver, because the expansion rate is different and requires you to adjust the valves more often. Note: When installing push rods, squirt some oil on the ends and down the hole.
Bug (Type 1): 36hp
Bus (Type 2): 36hp
Ghia: 36hp
No customer reviews for the moment.
Part #: 111198541GR
The cam rides in these bearings.
Application:Part #: N111521
This screw rides against your valve, opening and closing it.
Application:Part #: 1109406
These shims are used with the Solid Shaft Rocker Kit.
Application:Part #: 113109021GBR
We've had no luck with regrinds, therefore we sell only new camshafts.
Application:Part #: 1109612
Stainless steel valves are used in the big valve heads.
Application:Part #: 043109611A
The two outside valves in the head are the exhaust valves, they let the burned fuel out of the head.
Application:Part #: 1109410
These shims are used with the Solid Shaft Rocker Kit.
Application:Part #: JC91020
Jaycee Leak proof Pushrod Tubes, Black
Application:Part #: 111109345
Push Rod tube seal for 36 HP
Application:Part #: 1109339
These push rod tubes are spring loaded and are great for replacing bent tubes without having to pull the head(s) off.
Application:Part #: 113109612A
The two outside valves in the head are the exhaust valves, they let the burned fuel out of the head.
Application:Part #: 1109613
Stainless steel valves are used in the big valve heads.
Application:Part #: 113109612
The two outside valves in the head are the exhaust valves, they let the burned fuel out of the head.
Application:Part #: 1109642
If you are going to run dual springs we suggest you use these valve spring retainers as well.
Application:Part #: 1109338
These push rod tubes are spring loaded and are great for replacing bent tubes without having to pull the head(s) off.
Application:Part #: 1109336
These push rod tubes are spring loaded and are great for replacing bent tubes without having to pull the head(s) off.
Application:
These rods link the cam to the valves.
