Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
We have had good luck with this cam and prefer it over new stock cams and is a great cam when you want to stay with the stock carburetor or Kadrons.
We have had good luck with this cam and prefer it over new stock cams and is a great cam when you want to stay with the stock carburetor or Kadrons. It has good low and mid range. This cam comes with the three bolts for the gear.
Bug (Type 1): 40hp-1600
Bus (Type 2): 40hp-1600
Type 3: 40hp-1600
Ghia: 40hp-1600
Thing: 40hp-1600
Off-Road: 40hp-1600
No customer reviews for the moment.
Part #: 11094011
Rocker Arms Kit, HP Stock 1.1
Application:Part #: 1109605
Stainless steel valves are used in the big valve heads.
Application:Part #: 1109641
If you are going to run dual springs we suggest you use these valve spring retainers as well.
Application:Part #: 1109601
These caps go on the ends of the valve.
Application:Part #: JC91020
Jaycee Leak proof Pushrod Tubes, Black
Application:Part #: 1109398
These rocker studs are much stronger than the stock studs and are .100" longer to allow more flexibility when setting your rocker arm geometry..
Application:Part #: 1109400
This kit eliminates the clips and spring washers in a rocker shaft set up.
Application:Part #: 1109611
Stainless steel valves are used in the big valve heads.
Application:Part #: 1109341OR
Replacement O-Ring Set 16 pieces
Application:Part #: 113109601D
The two inside valves in the head are the intake valves, which let the gas into the combustion chamber.
Application:Part #: 111101401B
If you're rebuilding your own heads, you will probably need guides.
Application:Part #: 111109335
These tubes go from the case to the heads to house the push rods.
Application:Part #: 111109601A
Intake Valve 30mm (each)
Application:Part #: 1109302
These push rods are made out of chromoly steel and do not expand at the same rate as aluminum.
Application:Part #: 11310140108
If you're rebuilding your own heads, you will probably need guides.
Application:Part #: 1109651
We have had good luck with stock keepers on single springs.
Application:
We have had good luck with this cam and prefer it over new stock cams and is a great cam when you want to stay with the stock carburetor or Kadrons.
