Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
The cam rides in these bearings.
The cam rides in these bearings. We have tried German and Brazilian brands and have had good luck with both. If you are running a 1776cc or bigger engine you should run double thrust bearings. Note: The bearings are installed with the widest one towards the pulley and the narrowest one towards the flywheel. Use oil on the bearings before installing the cam. On the double thrust bearings you will need to file off the tang on one side of the thrust bearing. Also test fit the bearing to the cam before installing. It might need some sanding on the trust of the bearing to get them to fit.
No customer reviews for the moment.
Part #: 113109021GBR
We've had no luck with regrinds, therefore we sell only new camshafts.
Application:Part #: 1109641
If you are going to run dual springs we suggest you use these valve spring retainers as well.
Application:Part #: 1109002USA
Cam Gear without bolts USA Made
Application:Part #: 1109302
These push rods are made out of chromoly steel and do not expand at the same rate as aluminum.
Application:Part #: 113109612
The two outside valves in the head are the exhaust valves, they let the burned fuel out of the head.
Application:Part #: 1109400
This kit eliminates the clips and spring washers in a rocker shaft set up.
Application:Part #: 11310140102
If you're rebuilding your own heads, you will probably need guides.
Application:Part #: 1109305
Aluminum Smith Bros. Push Rods
Application:Part #: JC91030
Jaycee Leak proof Pushrod Tubes, Blue
Application:Part #: 1109451
This style of adjusting screw has a ball with a flat side on the end.
Application:Part #: 113109601B
The two inside valves in the head are the intake valves, which let the gas into the combustion chamber.
Application:Part #: 1109460
These shims are used under the rockers to set the geometry.
Application:Part #: 1109410
These shims are used with the Solid Shaft Rocker Kit.
Application:Part #: 113109651A
These springs return the valves back to their seats.
Application:Part #: 1109336
These push rod tubes are spring loaded and are great for replacing bent tubes without having to pull the head(s) off.
Application:Part #: 113101399B
Rocker Arm Stud
Application:
The cam rides in these bearings.
